Please select any question for a comprehensive answer. Results are displayed below.

	How do I select the right replacement tires for my motorcycle?
	Can I change my tires from bias ply to radial or vice versa?
	Can I put wider tires on my motorcycle?
	If I put higher speed rated tires on my motorcycle, will they upgrade performance?
	Why do motorcycle tires wear out so quickly compared to car tires?
	What purpose do directional arrows serve?
	I've heard many times that maintaining tire pressures is very important. How important is it?
	How can I keep my tires from cupping?
	How much run-in should I give a new tire?
	I have a tubed type tire. How often should I replace my tube?
	Can I have my motorcycle tires repaired?
	Can I use sidewall protectants or cleaners on my tires?

How can I keep my tires from cupping?

You may not be able to entirely avoid cupping. Tire cupping or irregular wear is a somewhat common occurrence on all vehicles. On a four-wheel vehicle, you are advised to rotate your tires periodically to even out wear. Unfortunately, you do not have this luxury with a motorcycle because front and rear tires, unlike those on a four-wheel vehicle, are not interchangeable. However, there are steps that can be taken to minimize cupping and uneven wear on a motorcycle: Maintain your motorcycle and particularly your front forks and suspension. Avoid hard braking whenever possible. Braking causes the tire to grab and wear in one direction. When braking is applied to the front tire, the load transfer over-flexes the tire and increases the tendency for cupping and uneven wear. Maintain your tire pressures. Underinflation or overinflation in motorcycle tires are significant causes of cupping and uneven wear, particularly in association with hard braking and/or trailer use. Some of today's tires feature tread patterns and constructions that are less prone to cupping than the ribbed tires of old. The Dunlop 491, D401 and D402 touring and sport touring tires are good examples. Tire companies can, and are, helping to minimize cupping and uneven wear but you, the rider, must do your part. Follow the aforementioned guidelines. How Much Run-in Should I Give a New Tire? When new tires are fitted, they should not be subjected to maximum power or hard cornering until a reasonable run-in distance of approximately 100 miles has been achieved. This is necessary for a number of reasons. Replacements for worn tires with different patterns and construction will not react the same. Also, a new tire is stiffer than an old tire. The new tire has a rounder tread profile, different contact patch and "lean-over edge" than the worn profile of an old tire. The new tire will also not react the same in combination with its remaining tire. Carrying out the required run-in will allow you to become accustomed to the "feel" of the new tires and tire combinations, so you are better able to achieve optimum road grip for use in high speed, high acceleration and handling situations.

Top of Page